20 Pcs 4 Pin RGB LED Light Strip Connector JACKYLED PBC 10mm Strip to Strip Solderless Connector for SMD 5050 Multicolor LED Strip
4Pin RGBW Connectors with Cable For 5050 RGB/RGBW LED Strip Light
Description:
❤10mm 4pin 12mm 5pin Connector with Cable For LED Strip SMD 5050 RGB/RGBW , No Need Soldering
❤Simple, tool-free installation
❤Reliable connect, good performance
❤Connector: 4pin 10mm
❤Material: PBT
❤Working temp: 0~40℃
❤Storage temp: -20~60℃
Installation Instructions:
❤Ensure your section of LED light strip has two contacts (+ and -) and the contacts are both clean
❤ Open the white clasp of the connector
❤ Insert the LED light strip into the clasp, under the prongs – making sure to match the + and – on the strip to the + and – on the clasp
❤Close the clasp
❤ Gently pull on the LED light strip to confirm you’ve made a solid connection
❤ Your connection is made!
Attention:
PCB Connector is only for
1. 5050 LED Strip Light
2. LED strip in RGBW color
Product Features
- MAX WATTAGE: 72W max wattage, these connectors can be used for both low and high wattage light strip.
- FIREPROOF MATERIAL: They are not made from cheap flimsy plastic like others. They are made from PBT material,which is heat resistant, anti-burning and no Fire Hazard.
- GOOD PERFORMANCE: The led light strip can be locked and connnected very tightly by the connector. 4 Pin LED Light Strip Connector better than the corner connectors because you don’t waste space with the wires that connect them, the two strips literally join together right at this connector.
- EASY TO USE: Open the wire clip. It should snap open with just a little effort.Insert your 10mm LED light strip inside the clip underneath the two contact prongs, making sure the side of the strip aligns with the + symbol.Close Snap the wire clip shut. Gently pull on the wire to confirm you’ve secured the strip inside the connector.
- PACKAGE:20 x 10MM 4 Pin For 5050 SMD RGB led strip Non-Waterproof. MAKE SURE you put the led strip under the pins and not on top. Also be sure to cut along the suggested line evenly so there is room for a proper connection on each side. 60 days changing or refunding without reasons. JACKYLED Products are sold and shipped by Jackybrand. If you purchase a product from another seller, please request a refund as it is a counterfeit. JACKYLED is the only Authorized Dealer of Jackybrand products.
Loading...
After doing a test run the strip worked just fine and the entire procedure took less than 2 minutes I ordered these knowing they are for 10mm strips, but I used them to repair one of my 12mm 6803ic LED strips that was damaged. I cut the strip where marked to remove the damaged section and trimmed the width of each end down with a razor knife. I then slipped the exposed copper ends under each side of the connector pins and clamped it down. After doing a test run the strip worked just fine and the entire procedure took less than 2 minutes. If the lights will be on a stationary object this…
Use solder on the wires I purchased these thinking they would help me with breadboard prototyping of 12v analog RGB light strips, and they do nicely.First, to insert the LED strip you simply be certain to slide the edges of the strip under the plastic edge tabs and the strip will align nicely with the contact fingers. The LED strips are marked for polarity (12v strips are (+) common) and the splice is marked for polarity on the shell.Second, I was happy I was able to slide Male-Female…