Dumble 12V RV Vent Fan Motor Replacement D-Shaft – RV Fan Motor, Camper Vent 12 Volt Motor, RV Exhaust Fan Motor

Say goodbye to smells and moisture and hello to clean air with the Dumble 12V Fan Motor. This power vent replacement motor is quiet and can be used for an RV vent fan such as a bathroom fan or a range hood fan. It is compatible with any 6-inch fan blade and vent system with a 0.125-inch D-shaped shaft. Not recommended for blades with bore holes that are larger than the vent motor shaft. You can pull your old plastic fan blades straight up and off from the old motor and reinstall the blades on this motor. Simply align properly and make sure the blade is completely pushed up to prevent the blades from hitting vent over or other surroundings. If the RV bathroom fan motor rotates in the wrong direction for your fan, simply reverse the wires on the motor. Installation hardware not included. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product Features

GOODBYE MOISTURE & SMELLS: Use the Dumble | RV Roof Vent 12V Motor with your existing fan to rid your RV, camper, or travel trailer of lingering smells in the bathroom and built-up moisture; This 12 volt fan motor is quiet and can be used to power an RV vent fan such as a bathroom fan or a range hood fan
EASY TO INSTALL: Wire your fan to the motor switch, then wire the switch to your RV; Ensure that the wires connect black to black (grounds) and the other wires connect together; Save your old fan blades – Pull on the hub (center part of blades) off the shaft and push the center hub of the blades back on the new motor shaft (Flat side on motor shaft used to align the hole in the hub and slide on); Mounting screws and fan blade not included
ROTATION: This power vent motor has reverse polarity, meaning that it can be wired to turn in either clockwise or counter-clockwise rotations; Rotation direction depends on your fan blade wiring (one wire goes to the hot side of switch, other goes to ground); To determine the direction of spin on your existing fan, look down through the motor at the top of the blade
FITS YOUR RV: 1/8-inch diameter x 3/5-inch length (3.17mm x 15mm) half-moon (D-shaped) shaft; 1-2/5-inch diameter x 2-1/5-inch length (36mm x 57mm) body; Fits Elixir, Heng’s, Jensen, Ventline, and similar 6-inch (15.2cm) fan blades; Compare this unit measurements with your current unit to ensure exact fit
BUILT TO LAST: 1.5W working power; 5,000 RPM; 18AWG*2 terminal connect cords (White 20-inch/50.8cm with 10-inch/25.4cm black jacket; Black 10-inch/25.4cm with 7.5-inch/19.1cm black jacket); 12-volt DC (cigarette lighter) power connection (not intended for house or wall plugs)