JULLISON LED 4 Packs Recessed Low Profile Slim Panel Light with Junction Box, Air Tight, 4 inch, 9W, 550 Lumens, 4000K Neutral White, CRI80+, Dimmable, cETLus – Listed, Energy Star Certified
IMPORTANT:
Read all instructions before installing fixtures. Retain for future reference.
SAFETY:
For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
WARNING:
Make certain power is OFF from the electrical panel before starting installation or attempting any maintenance. Indoor installation only.
TOOLS REQUIRED:
1.Saw
2.Measuring Tape
3.Electrical Wiring (use type and gauge suitable for application to connect the fixtures)
PRE-INSTALLATION:
1.Turn power OFF from the electrical panel before starting installation.
2.Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
3. Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
FIXTURE INSTALLATION:
1. Connect the fixture to the hardwire box by inserting and twisting the male/female connectors.
2. Push spring loaded clips on the fixture upwards and insert fixture base in to mounting hole. Release the clips and fixture will be pulled flush to the ceiling.
3. Once assembly is complete, turn on power to confirm fixture is working properly.
Hole Cut Size
4-1/4”. Please follow the cut out template with the product.
Product Features
- 1- 4″ round LED light fixture with isolated external driver installed inside junction box.
- 2- Ultra-thin, 1″ thick LED fixture, edge-lite, consumes 9W, emits over 550 lumens at 4000K and CRI 80+, offers comfortable soft white light and less glare to eyes.
- 3- Type IC rated, approved for direct contact with insulation and NO pot light housing is required; Air-tight and suitable for damp location.
- 4- For new construction, insulated and dropped ceilings, easy to install into the 4-1/4″ cut out.
- 5- Dimmable with triac and ELV dimmers; cETLus and Energy Star Certified.
One LED driver caused the AFCI/GFCI breaker to trip I installed all four from this pack. Three worked perfectly, and everything was a breeze to install. However, three of them were wired in a series on one switch. Once everything was wired I went to flip the combination AFCI/GFCI breaker back on, the AFCI/GFCI would trip. I rechecked all of the wiring and found no issues. I eventually troubleshot it by removing lights one-by-one on the circuit and flipping the breaker on so that I could track down the short. The final LED driver on the circuit…
Very satisfied. These lights are an absolutely incredible value for the price. They come very well packaged and are very easy to install with the ‘wafer’ LED being separated from the junction box. You can install these virtually anywhere because of the extreme low profile. Mine went around my outside soffit and drilling just under a rafter wasn’t a problem at all with very little clearance needed. If LED to jbox extension cords become available your install options become almost limitless. They look…